High-quality sealant based on acrylic dispersion that provides a long-lasting, permanently flexible seal that can be overpainted when cured.

Uses: For sealing and filling joints around timber, aluminium and uPVC window frames & doors, stairs, walls, ceilings, skirtings, windowsills, concrete and brickwork Surface

Preparations: Application temperature +5°C to +40°C. All substrates must be clean, dry, and free of grease and dust.

Application instructions: Cut the tip of the cartridge taking care not to damage the thread.

Apply nozzle and cut cleanly at an angle of 45° with an opening slightly larger than the gap to be sealed.

Apply using a standard sealant gun.

Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed.

Smooth down within 20 minutes of application using a welted spatula, piece of wood or wetted gloved finger.

Care should be taken at this point not to saturate the surface as this will delay drying.

Cleaning: Tools should be cleaned after use with water. Sealant can be cleaned with water and soap before curing.

Limitations: Not suitable for continues exposure to water. Not suitable for PP, PE, PC, PMMA, PTFE, soft plastics, neoprene and bituminous substrates.

CAUTION: Keep out of reach of children. Wash skin thoroughly after handling, Wear protective gloves/eye protection/face protection.

Dispose of contents/container in accordance with local regulation.

Safety data sheet available on request.

Bathe the eye with running water for 15 minutes.

If irritation persists seek medical attention